longevitymuscle

SS-31

Also known as Elamipretide, MTP-131

Mitochondria-targeted peptide studied for mitochondrial disease.

Medical status: Investigational for rare mitochondrial and kidney disease.

Also commonly used for (off-label)

  • Mitochondrial fatigue protocols
  • Longevity and endurance research

Off-label and research uses are what people report, not approved indications. Talk to a clinician before using any of them.

How it's taken (route)

Documented dose
1–6 mg
Typical frequency
Once daily, 3–5 days per week (mornings)
Cycle
12 weeks on, 4 off
Half-life
~2 hours
Common vial sizes
10 mg, 50 mg
Regulatory status
Investigational; not approved.

Dose on a U-100 syringe (1–6 mg)

VialBAC waterDraw
10 mg1 mL10–60 unitslarge volume
10 mg1.5 mL15–90 unitslarge volume
50 mg2.5 mL5.0–30 units
50 mg3 mL6.0–36 units

On a U-100 syringe, 100 units = 1 mL, and the syringe holds 100 units total. Most people keep a single subcutaneous injection under about 50 units — bigger volumes are usually mixed stronger (less water) or split into two shots. Only mixes that fit in one syringe are shown. Always double-check with the reconstitution calculator.

What it does

Also called elamipretide. It travels into the mitochondria and binds to cardiolipin, a fat that keeps the energy-producing machinery folded correctly. Think of it as tuning up the cell's power plants. What people look into it for: • Chronic fatigue and low energy tied to mitochondrial function • Heart and skeletal muscle performance • Recovery in older adults or after illness • Reducing oxidative stress and supporting healthy ageing It has been through real clinical trials for rare mitochondrial diseases, with mixed but promising results.

Mechanism

Binds cardiolipin on the inner mitochondrial membrane, improving electron transport efficiency.

Storage — lyophilisedwhat's this?

Refrigerate 2-8C, protect from light.

Storage — reconstitutedwhat's this?

Refrigerate 2-8C, use within ~28 days.

Reconstitution noteswhat's this?

Common mix: 10 mg vial + 2 ml bacteriostatic water = 50 mcg per unit, so 1 mg is 20 units, 3 mg is 60 units and the 6 mg ceiling is 100 units. A 50 mg vial + 3 ml gives 167 mcg per unit (3 mg ≈ 18 units).

Stacks well with

Popular combinations reported in the community and research literature — not a recommendation. Adding peptides multiplies side-effect risk; check with a clinician.

Commonly reported side effects

  • Injection-site reactions
  • Headache
  • Dizziness

Contraindications noted

  • Pregnancy or breastfeeding

Research notes

In clinical trials as elamipretide for primary mitochondrial myopathy.

Vendors carrying SS-31

These research suppliers list this compound. Prices, vial sizes and testing vary — always check the current lot certificate before you buy.

Peptide Streak users get 15% off PeptideMaxxing with code PEPSTREAK.

Peptide Streak does not sell peptides and is not affiliated with these vendors. Some list metabolic compounds under coded product names.

Track this properly

Work out syringe units with the calculator, or set up a full schedule in about a minute.

Reference information only, not medical advice. See our medical disclaimer.